1999 BMW M3 - 79k miles on IP Spec Motor. MCS 2WNR suspension - M Hurricane front and rear seats (small hole in drivers seat fabric but otherwise clean).
Recent Maintenance: Every ounce of fluid changed, waterpump, thermostat, fuel filter, battery, all 4 shocks filled and adjusted to 175psi,
new rotors and pads, new speed sensor, brand new wheels and tires (71REs) at Rogue Engineering in Nov 2023. Driven less than 300 miles since.
Used track insurance to fully respray car in 2020 following an incident at NJMP. Car was driveable and I infact put down a personal best at on thunderbolt.
On to the good stuff:
Engine & Transmission:
Bosh 24lb Injectors
BW 3.5 Intake
Epic large cams
Vanos Shimmed For Large Cams
Porsche HFM
Rogue Power Pulley Set
Supersprint Euro Headers
Bimmerworld Race Exhaust
Rebuilt Head: New Valves, keepers, retainers, seals, all machine work etc.Head removed, resurfaced, new head gaskets & all other gaskets, head bolts, tensioner, etc.
New Oil Filter Housing & Gasket
New Belts
New Plugs
Cooling system redone, Thermostat, Water Pump, Hoses.
Valve cover gasket & all gaskets when the rest was done
Oil Pan Baffled
Oil Pump Nut Welded
S54 Oil Filter Housing
Oil Cooler
All Power Steering Lines Replaced
Bimmerworld Fuel Starvation Kit
m50 intake manifold
TRM Tune
SACHS Clutch
JB Racing Flywheel
Exterior & Interior:
M Hurricane Front & Rear Seats (small hole in driver bolster, otherwise very clean)
No armrest new center console
Sparco steering wheel
Swapped 95 nose panel and black grills
Kirk 4pt Roll Bar
Euro Glass Headlights/harness
Brakes:
Zimmerman Blanks
Hawk DTC60 Front & Rear Pads
BFG Brake Lines
Suspension:
MCS 2 way - Sent to MCS for rebuild/service in 2017
Rear Subframe Welded & AKG Bushings
RTAB Pockets Welded
Ground Control Rear Control Arms
Ground Control Rear Shock Mounts
AKG Front Subframe Plates Welded
AKG Sway Bar Reinforcement Kit
Bimmerworld Solid Motor/Trans Bushings
New Factory Front Control Arms
AKG Front Control Arm Bushings
New Wheel Studs
Ground Control Race Trailing Arm Bushings
Ground Control Race Camber Plates
New Center Support Bearing